INDUSTRY

ThermaCote® SOLUTION

Save energy and maintenance costs in industrial applications.

WAREHOUSES, HVAC, CHILLERS, STEEL, ALUMINUM, STEAM LINES, STEEL BEAMS, FRAMING, STEEL CONTAINERS, SILOS, PIPES, VALVES

ThermaCote® is the perfect solution for insulating valves and pipes in an industrial line.For hot applications ThermaCote® can be applied while the unit is operational and at temperatures to 149C/300F and with special training up to 210C/410F.

Since ThermaCote® incorporates corrosion inhibitors, no primer is necessary in most cases.

Protects against moisture, thermal transfer, thermal bridging and conduction, and self primes

Industrial applications utilizing ThermaCote® are applied in approximately 0.25mm coats, allowing for complete drying before recoating until proper thickness or ‘build’ is achieved.Without complete drying between coats, moisture encapsulation will ultimately result in product failure.

Cryogenic applications must be performed at ambient temperature and fully dried and cured before returning to cold service.

Apply directly to freshly blasted steel as well as stainless steel and aluminum

Oil and Gas

PIPES, STORAGE TANKS, JETTIES, VESSELS, STRUCTURAL STEEL, FACTORY ROOFS

ThermaCote® was the first fluid applied water based coating used to combat CUI (corrosion under insulation) in the mid-80s. With built in corrosion inhibitors ThermaCote® can protect fresh blasted steel from ‘flash’ or surface rust by applying it as a primer & topcoat all in one product.Areas that already have corrosion issues or that are extremely prone will require an additional primer prior to application.

ThermaCote® has been used in North America for decades to prevent heat loss on industrial pipe systems (oil pipelines) which carry materials that must maintain temperatures at or above 325F/161.5C.

Can be applied to surfaces as hot as 410° F/ 210C. No harmful fumes emitted at any point before, during or after application. Flame spread of 0 (zero)

Built-in corrosion inhibitors, personnel protection, and consistent flow through piping.

ThermaCote® is a product that protects substrates, and personnel from contact burns. As well, this product delivers all of the insulation needed in most cases for piping, tanks and other vessels for temperatures up to 410F/210C in continuous operation while systems are hot.LNG Gas ‘balls’ (storage tanks) and all other related equipment can benefit from the lowered surface temperatures which will remain closer to the ambient temperature conditions with ThermaCote®.

A simple 1-1.5mm thickness is all that is needed to control temperature ‘heat gain’. ThermaCote® on a substrate controls the temperatures inside a LNG gas system during storage and transport as well.

ROOFS

FACADES

SPECIALTY

FLOORS